الأربعاء، 29 نوفمبر 2017

#course:Piping and Pipelines network design, optimization and simulation

يتشرف المركز الدولي للتدريب والاستشارات ان يقدم لكم برامجه المتخصصة في
اقوي الدورات التدريبيه التي يحتاجها سوق العمل و التي هي الأكثر طلبا في المجالات المختلفة والشاملة....



course:#Piping and Pipelines network design optimization and simulation

Course Objectives:

·         The pipeline networks expanded rapidly all over the world when it became apparent that pipelines are an efficient, economic way to move oil, gas, and petroleum products to consumers. The large discoveries of oil and gas, many of them in remote areas of little local demand, promoted this pipeline expansion. More challenges face the pipeline industry. So, good understanding of pipeline systems will help tackling these challenges.
·         This course deals with the design, construction of both gas and liquid pipeline systems. An overview of pipeline industry is discussed.  Participants will have acquire and/or consolidate the essential knowledge and skills to design and construct pipelines. This will allow them to contribute to cost effective, safe and sound-design of pipelines.
·          Pipelines network design
·         Analyses and optimize network performance through computer simulation
·         Simulate  the pipelines , performance  and troubleshooting
·         Simulate hydrate formation , slug problem
·         Analyses  the flow equipments  operation  ( pumps , compressor , fitting , valves ) by simulation softwares
·          

Who Should Attend:

·         Managers, engineers, operators, supervisors, inspectors, equipment suppliers, or those who wish to be familiar with pipeline systems
·         Operations personnel who are involved in the use of pipelines either liquid or gases or network system
·         Design engineers who are involved in the design, modification or repair of pipelines or network system
·         Maintenance personnel who are involved in or responsible for the routine maintenance of the network  system
·         Safety engineers who are involved in the continuing assessment of the pipelines system as a safe means of transportation

·        Environmental engineers


Course Contents and agenda: 
  •         Pipeline Design
  •   Design Sequence of P/L network
  •      Evaluation of fluid availability
  •      Estimate of fluid demands.
  •      The Basic design of P/L network.
  •      The Economics of P/L system.
  •   Fluid properties affecting flow
  •        Design of Gas Pipelines
  •   Calculation of compressibility factor.
  •   Properties of gas mixtures.
  •   Pressure drop in gas pipeline due to friction.
  •   Gas pipeline flow equations.
  •   Friction factor and transmission factor.
  •   Gas Pipeline velocity and erosional velocity calculation.
  •    Increasing gas throughput by looping and booster compressor.
  •   Calculation of pipe maximum allowable operating pressure.
  •    Fundamental Calculations of gas compressor stations.


كما يقدم المركز باقة من أحدث البرامج التدريبية وورش العمل في المجالات التالية:

خدمة عملاء وتسويق و مبيعات ومالية ومشتريات و مخازن و دورات هندسية وامن وسلامة
موارد بشرية وإدارة و قيادة  و دورات قانونية وسكرتارية وعلاقات عامة



لمعرفة المحتوى العلمى والتكلفة والمواعيد الاخرى للدورة فى انتظار تواصلكم 


 Bassma genedy

Training coordinator

:bassma@itcegy.comE-Mail

00201113010104Mobile:












الأحد، 26 نوفمبر 2017

#Course:Advanced Oil Treatment technology

يتشرف المركز الدولي للتدريب والاستشارات ان يقدم لكم برامجه المتخصصة في
اقوي الدورات التدريبيه التي يحتاجها سوق العمل و التي هي الأكثر طلبا في المجالات المختلفة والشاملة....


نقدم لكم مجموعة مختلفه وشاملة من الدورات والكورسات في مجال البترول 

#Course:Advanced Oil Treatment technology

:Course Objective

·   Understand the fundamentals of separation in vessels by Gravity.
·    Operate and Troubleshoot Separator Problems.
·    Identify Emulsions, Emulsifying Agents, and Demulsifies.
·    How to operate and troubleshoot Heater-Treaters
·    Understand the Basic Pump Hydraulics.
·    Identify Storage Tank Types and components.
·    Identify Hazardous Conditions and apply Safety Procedures.
·    Know the required measurements for oil the storage tanks (Gravity,  Temperature, Volume, Salt Content, Water and Sediment)

:Course Contents

·     Fundamentals of separation in vessels
·     Separators Operation and Troubleshooting. 
·     Fundamentals of Crude Oil Emulsions
·     Method for treat emulsion
·     Operation , configuration and Sizing of Heater-Treaters
·     Electrostatic Heater Treater Operation, configuration and Sizing.
·     Basic Pump Hydraulics.
·     Types of pumps and pump system , troubleshooting
·     Hazardous Conditions, Safety Procedures and Measurements.
·     Storage Tank Types and components.
·     Storage tanks correction and calibration methods

:WHO SHOULD ATTEND
1.      Operation Supervisors
2.      1st Line Maintenance personnel
3.      Maintenance Supervisors
4.      Senior Plant Supervisors
5.      Operations Engineers
6.      Process Support Engineers
7.      Design Engineers
8.      Process and Production staff
9.      Projects and Constructions Engineers

Course Duration:  5  Days



كما يقدم المركز باقة من أحدث البرامج التدريبية وورش العمل في المجالات التالية:

خدمة عملاء وتسويق و مبيعات ومالية ومشتريات و مخازن و دورات هندسية وامن وسلامة
موارد بشرية وإدارة و قيادة  و دورات قانونية وسكرتارية وعلاقات عامة


لمعرفة المحتوى العلمى والتكلفة والمواعيد الاخرى للدورة فى انتظار تواصلكم 


 Bassma genedy

Training coordinator

:bassma@itcegy.comE-Mail

00201113010104Mobile:





الأربعاء، 22 نوفمبر 2017

Advanced Gas liquid separation

يتشرف المركز الدولي للتدريب والاستشارات ان يقدم لكم برامجه المتخصصة في
اقوي الدورات التدريبيه التي يحتاجها سوق العمل و التي هي الأكثر طلبا في المجالات المختلفة والشاملة....


Advanced Gas liquid separation:course#



COURSE OBJECTIVE :to gain

Ø  Identify principle and theory of separation  
Ø  Identify the separator configuration
Ø  Explain separator internal and sizing
Ø  Stage separation and phases of separation
Ø  Understand operating procedures and put them into practice
Ø  Troubleshoot typical operating problems


WHO SHOULD ATTEND?
Ø  People who are making day to day decisions regarding operation, design, and economics of processing plants;
1.      1st Line Operations personnel,
2.      Operation Supervisors,
3.      1st Line Maintenance personnel,
4.      Maintenance Supervisors,
5.      Senior Plant Supervisors,
6.      Operations Engineers
7.      Process Support Engineers,
8.      Design Engineers,

Ø  Ideal for veterans and those with years of experience who want to review or broaden their understanding in Processing Plant Operations.
Ø  Other professionals who desire a better understanding of subject


COURSE DURATION:

4- 5   days




كما يقدم المركز باقة من أحدث البرامج التدريبية وورش العمل في المجالات التالية:

خدمة عملاء وتسويق و مبيعات ومالية ومشتريات و مخازن و دورات هندسية وامن وسلامة
موارد بشرية وإدارة و قيادة  و دورات قانونية وسكرتارية وعلاقات عامة



لمعرفة المحتوى العلمى والتكلفة والمواعيد الاخرى للدورة فى انتظار تواصلكم 


 Bassma genedy

Training coordinator

:bassma@itcegy.comE-Mail

00201113010104Mobile: